Seeing wells with the same coordinates

[EliVolsch]

Good afternoon,

In the GGMN, there are several wells with the same coordinates. In these cases, when you click on a point, various wells will be shown in the panel on the right, once after the other.

When you use the attribute table to search for wells, if the well you are searching share coordinates with other wells, the panel in the right will show all of them. This is fine, but I would like to request that the first well shown corresponds to the one that has been queried.

The reason that this issue arises is that I was looking for the well 08036X0954/GBDX2 (France). I looked for it using the attribute table, and then Zoom to feature. When I clicked on the point, the first well to shown is 08036X0019/F, but it took me a while to figure out that I was looking at the wrong well. So, to avoid confusions, it would be better that the first one to be shown is the one that has been queried, in this case, well 08036X0954/GBDX2 (which is now shown in 6th place).

Thanks, and please let me know if something is not clear.

Kind regards,
Claudia