Skip to content

Latest commit

 

History

History
45 lines (30 loc) · 1.73 KB

WebUI_Dashboard.md

File metadata and controls

45 lines (30 loc) · 1.73 KB

The Web interface - Dashboard page

Please refer to STEP 3 Plugin Configuration to get access to the Web interface administration.

Here is the Dashboard page of the plugin Web interface :

Dashboard

This picture may have have changed since this documentation was written.

Contents

The 3 top graphics

They shaw the traffic state :

  • Outgoing
  • Incoming
  • Type and load

The 3 bottom graphics

They shaw the device state :

  • Type
  • Health
  • Battery level

Look at the other pages of the plugin Web interface.

This is a Plugin Dashboard from which you can in a short time if anything else is going wrong on the coordinator environment. This is some how self explanatory and you have comments for each section. In the header where you have the navigation tabs, you have also a switch which allow you to move coordinator and plugin into Pairing Mode (In case coordinator is already in pairing mode, the switch will automatically enabled).

In the footer (here in Green) you have some quick overview of :

  • when the plugin has been started

  • a quick plugin status "Ready" here

  • the Plugin Version

  • the Firmware version on coordinator

  • Tx (Total Transmission) is the total number of transmissions (from other networks) detected during the scan

  • Failure (Transmission Failure) is the number of failed transmissions detected during the scan

  • Energy-Level measurement reports energy-level measurements (the value 255 indicates there is too much interferences on the channel).

In short, higher the value is , indicates a high interferences, worst it is. Better to select an other channel with lower level.